Questions
-
Possible to use larger/heavier end mills?I've been carving out wooden bowls using a 8mm ball end bit. I was wondering if it was possible on the workbee to use much...
-
Adobe Illustrator to G codeI do a lot of work in Illustrator and was looking at this plug in which claims to export G Code from it. Is there any way...
-
How to learn gcode/macrosWhat is the best resource for learning enough about gcode to make simple macros which will identify positions for the...
-
Switching on and off from plug socketDue to the layout of my workshop (and the fact that the power pack’s on/off switch is right at the back of the machine) I...
-
problem with corner probe and machine limitsI’m trying to probe the corner and getting the ‘outside machine limits’ message. Is there a common reason/solution for...
-
crude contours after finishing passI have been trying to cut a 3D head using a Machine Relief toolpath in Carveco software. I carried out the roughing cut...
-
Changing z during jobSay I’ve started my job and find that it’s skimming just above the surface of the wood. Is it possible to lower the z...
-
workbee behaving as though surface is unevenI’m cutting both profiles and area clearances (workbee 1500, carveco software). It’s a fairly small sheet of 3 mm ply (40...
Answers
-
Answer to "workbee behaving as though surface is uneven"What does surfacing the spoilerboard mean please?
Reputation over time
Reputation Breakdown
| Event | Count | Delta |
|---|---|---|
| Accepted answer | 4 | 40 |
1072